PUNTO SWITCHER 3.3.1 HOW TO
PUNTO SWITCHER 3.3.1 PASSWORD

interface pptp-server server set enabled=yes mrru=1600ДЄssign local and public addresses to proper interfaces. MRRU allows to enable multi-link support over single link, it divides the packet to multiple channels therefore increasing possible MTU and MRU (up to 65535 bytes) To ensure proper operation itbis suggested to override the value by specifying MRRU option in server settings to a higher value. When bridging packets PPP tunnel need to pass packets with Layer-2 (MAC) header included, so default interface MTU (in case of pptp it is 1460) is not sufficient for this task. ppp secret add profile=ppp_bridging name=ppp1 password=ppp1 ppp profile add name=ppp_bridging bridge=bridge_local use-encryption=yes

PUNTO SWITCHER 3.3.1 PASSWORD

In case you use PPP only for bridging, configuration of the ppp profile and secret is very easy - just assign user name and password in secret) and specify bridge option in the profile. ip address add address=1.1.1.1/24 interface=ether2_public ip address add address=192.168.88.1/24 interface=bridge_local Now we can assign local and public addresses to proper interfaces. // where xx:xx:xx:xx:xx:xx is MAC address of the ether1_local interface interface bridge set bridge_local admin-mac=xx:xx:xx:xx:xx:xx interface bridge port add bridge=bridge_local interface=ether1_local interface bridge add name=bridge_local protocol-mode=rstp Reason for that is simple - when BCP is used PPP bridge port do not have any MAC address.

PUNTO SWITCHER 3.3.1 HOW TO

Below you will see how to set configuration using Winbox and CLI.Д«CP Configuration (CLI) Office 1 configurationДЇirst we need to create bridge interface and make sure that bridge will always have MAC address of existing interface. Office I is going to be used as PPTP server, Office 2 is going to be used PPTP client. We have two offices, which are remotely located. Let's see, how it is possible with PPTP tunnel and BCP protocol usage We have requirement to use encryption to protect data exchange between two offices. We need to interconnect two remote offices and make them in one Ethernet network. MikroTik RouterOS can be used with other PPP device, that supports BCP accordingly to the standards, but BCP enabled is necessary. BCP can be used instead of EoIP + used VPN Tunnel or WDS link over the wireless network.Д«CP (Bridge Control Protocol) should be enabled on both sides (PPP server and PPP client) to make it work. Established BCP is independent part of the PPP tunnel, it is not related to any IP address of PPP interface, bridging and routing can happen at the same time independently. BCP allows to bridge Ethernet packets through the PPP link. RouterOS supports BCP (Bridge Control Protocol) for PPP, PPTP, L2TP and PPPoE interfaces.

Punto switcher 3.3.1